User`s manual

Moxa C Programmable RTU Controllers Getting Started
2-8
STEP 2: Install the Moxa PComm Lite to the host Windows PC.
STEP 3: Run the PComm Lite Terminal Emulator from Start\Programs\PComm Lite Ver 1.x\Terminal Emulator.
STEP 4: Click on Profile\Open.
STEP 5: Specify the COM port that is connecting the RTU controller, and configure the settings to 115,200, 8,
none, and 1.
STEP 6: Click on the Terminal tab, and configure the Terminal Type to VT100. Click OK to proceed.
STEP 7: Serial console will be displayed on the terminal screen.
Telnet Console
It will be easy to use the system embedded command “telnet” to connect the RTU controller via network
connection. The default IP address and Netmask are given below:
Default IP Address
Netmask
LAN 1 192.168.127.254 255.255.255.0
Use a cross-over Ethernet cable to connect directly from the host PC to the RTU controller. User must first
modify the host PC’s IP address and netmask to be in the same subnet as the target RTU controller. For