User`s manual

Moxa C Programmable RTU Controllers Getting Started

2-5

ioPAC 8020-C Series

ioLogik W5348 Series:

Powering on the RTU Controller

Connect the 12 to 36 VDC power lines from the power supply to the Moxa C programming RTU controller’s

power terminal block, and then power on the power supply attached to it. It takes about 30 to 60 seconds for

the system to boot up. Once the system is ready, the Ready LED will light up.

Power Terminal Block for ioLogik W5348-C Series

Power Terminal Block for ioPAC 8020-C Series

Grounding Nut