User`s manual

Moxa C Programmable RTU Controllers Getting Started
2-4
Removing ioPAC 8020-C Series from the DIN-Rail
To remove the ioPAC 8020-C from the DIN-rail, use a screwdriver to push down the spring-loaded bracket until
it locks in place, as shown in the diagram to the right. Next, rotate the bottom of the switch upwards and then
remove the switch from the DIN-rail.
ioLogik W5348-C Series
STEP 1: Insert the top of the DIN-rail into the slot just below the stiff metal spring.
STEP 2: The DIN-rail attachment unit will snap into place as shown below.
To remove the ioLogik unit from the DIN-rail, simply reverse Steps 1 and 2 above.
Grounding the RTU Controller
The Moxa C programming RTU Controller is grounded to enhance EMS performance. The RTU controller comes
with a metal DIN-Rail bracket for grounding the system. For optimal EMS performance, connect the chassis
ground nut on the RTU controller to the grounding point.