User`s manual

UC-7112-LX Plus Software User’s Manual Getting Started
2-7
Modifying Network Settings over the Network
IP settings can be activated over the network, but the new settings will not be saved to the flash
ROM without modifying the file
/etc/network/interface s .
For example, type the command
#ifconfig eth0 192.168.1.1 to change the IP address of LAN1
to 192.168.1.1.
root@Moxa:~# ifconfig eth0 192.168.27.125
root@Moxa:~#
Installing a Secure Digital (SD) Memory Card
The UC-7112 and UC-7112 Plus have an internal SD socket for storage expansion. For the
UC-7112, a Secure Digital (SD) memory card compliant with the SD 1.0 standard can be used to
provide up to 1 GB of additional memory space. In addition, the UC-7112 Plus supports Secure
Digital High Capacity (SDHC) memory cards that are compliant with the SD 2.0 standard, and can
be used to provide up to 16 GB of additional memory space.
In this section, we explain how to install the SD card in the UC-7112-LX Plus.
The SD slot is located on the right side of the UC-7112 Plus enclosure. To install an SD card, you
must first remove the upper enclosure of the UC-7112-LX Plus to access the slot, and then plug
the SD card directly into the slot.
The SD card will be mounted at /mnt/sd. Detailed installation instructions are shown below:
Step 1: Loosen the screws on the sides of the UC-7112-LX Plus’s outer casing.
Step 2: Remove the UC-7112-LX Plus’s outer cover.