User`s manual

UC-7112-LX Plus Software User’s Manual Getting Started
2-4
Use a straight-through Ethernet cable to connect to a hub or switch that is connected to your local
LAN. The default IP addresses and netmasks are shown above. To log in, type the Login name and
password as requested. The default values are both root:
Login: root
Password: root
You can proceed with configuring the network settings of the target computer when you reach the
bash command shell. Configuration instructions are given in the next section.
ATTENTION
Serial Console Reminder
Remember to choose VT100 as the terminal type. Use the cable CBL-4PINDB9F-100, which
comes with the UC-7112-LX Plus, to connect to the serial console port.
Telnet Reminder
When connecting to the UC-7112-LX Plus over a LAN, you must configure your PC’s Ethernet
IP address to be on the same subnet as the UC-7112-LX Plus that you wish to contact. If you do
not get connected on the first try, re-check the serial and IP settings, and then unplug and re-plug
the power cord.