Specifications

fSTOP Wireless V2-1 BarTech Receiver Manual 30-Dec-13

www.plcelectronicsolutions.com 6 of 20

3. fSTOP Wireless V2-1 BarTech Receiver Setup

3.1. Power

The fSTOP Wireless V2-1 can use anything between 8 – 30 volts and incorporates

internal voltage up conversion, so no matter the input voltage you will always get a fast

response on the motor.

Your power source must be able to source up to 3.0 Amps otherwise motor performance

will suffer.

3.2. Single fSTOP Wireless V2-1 Operation

a. On the BFD Handset choose one channel from 0 to 7 by rotating the selector until

the arrow points to the desired channel. The selector can be turned in either

direction.

b. Using the CHAN switch on the fSTOP Wireless V2-1 select the same channel you

chose above by rotating center selector with a small tool until the arrow points to the

desired channel. The selector can be turned in either direction.

a. The focus wheel on the BFD Handset now controls the fSTOP Wireless V2-1. The

Rx light on the fSTOP Wireless V2-1 will rapidly flash green to indicate received

data.

As a general rule, you can further reduce the potential for video transmitter interference by

choosing the channel with the highest number.