Specifications

fSTOP Wireless V2-1 BarTech Receiver Manual 30-Dec-13

www.plcelectronicsolutions.com 5 of 20

2.3. fSTOP Wireless V2-1 BarTech Receiver

a. Attach the Antenna (PLC477-0001) to the fSTOP Wireless V2-1 BarTech Receiver

(PLC955-0029).

b. Plug one end of the fSTOP Power Cable into the power output connector of a

camera or battery and the other end into the 2pin Lemo connector on the fSTOP

Wireless V2-1.

c. Attach the motor to the gearing of the desired focus, iris or zoom gear on the lens.

Plug one end of the 7pin motor cable into the digital motor and the other end into the

7 pin connector of the fSTOP Wireless V2-1.

Do not power up the system at this time.

**You must ensure that the Camera Power output connector is able to source 3.0

Amps if you wish to power the fSTOP Wireless V2-1 directly from the Camera

otherwise motor performance will suffer.**