Specifications

fSTOP Wireless V2-1 BarTech Receiver Manual 30-Dec-13
PLC Electronic Solutions Ltd. Copyright © 2013
www.plcelectronicsolutions.com 17 of 20
6. Troubleshooting
6.1. Automatic Calibration
The motor will not calibrate to the full span of the lens.
 Try increasing the torque settings. See section 3.5 Torque Setup.
The motor moves to the first stop and continues to turn.
 Try decreasing the torque settings. See section 3.5 Torque Setup.
6.2. Manual Calibration
The motor does not move in manual calibration mode.
 If a manual calibration has be set into the fSTOP Wireless V2-1 memory without
moving the motor the span will be set to 0 so the motor will not move. Simply press
the CAL button and start the manual motor calibration again. See 3.6. Manual
Motor Calibration for directions.
6.3. Connectivity
I cannot get the fSTOP Wireless BarTech Receiver V2-1 to receive the signal from the
transmitter.
 Check that the BFD Handset and fSTOP Wireless V2-1 are set to the same
channel.
 Look for the Rx light flashing on the fSTOP Wireless V2-1. If the Rx light is flashing
green the BFD Handset and fSTOP Wireless V2-1 are communicating.