User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Before Getting Started
- Setting up an Ethernet Environment
- Cable Connection
- Powering on VPort 2140 Video Server
- Assigning an IP Address to VPort 2140 Video Server
- Working in a DHCP Server Networking Environment
- Installing the VPort Installation Wizard
- Running the VPort Installation Wizard
- Working in a Non-DHCP Server Networking Environment
- Assigning the IP Address Manually
- Accessing VPort 2140 Video Server for the First Time
- Setting up a Modem Environment
- Mounting VPort 2140
- 3. Accessing VPort 2140 Video Server for the First Time
- 4. System Configuration
- 5. Advanced Applications
- 6. Upgrading System Firmware
- 7. Troubleshooting
- A. URL Commands of Video Server
- Page URL
- System Resource URL
- General Format of Command URL
- System Configuration URL
- Security Configuration URL
- Network Configuration URL
- Video Configuration URL
- Image Quality Configuration URL
- COM 1 Configuration URL
- COM 2 configuration URL
- Camera custom command configuration URL
- Camera preset configuration URL
- Custom camera configuration URL
- Application configuration URL
- Motion detection configuration URL
- Demo configuration URL
- Homepage layout configuration URL
- B. Settings of Supported PTZ Cameras
- C. Camera Control Cable
- D. Time Zone Table
- E. Technical Specifications
- F. Service Information
VPort 2140 User’s Manual URL Commands of Video Server
A-9
showalert <not required> show alert in image
mdch1 <not required> enable motion detection on video 1
mdch2 <not required> enable motion detection on video 2
mdch3 <not required> enable motion detection on video 3
mdch4 <not required> enable motion detection on video 4
di1 High, Low, Rising, Falling or
Disable
DI1 condition
di2 High, Low, Rising, Falling or
Disable
DI2 condition
di3 High, Low, Rising, Falling or
Disable
DI3 condition
di4 High, Low, Rising, Falling or
Disable
DI4 condition
delay <integer> delay time of DO after event
do1 High, Low or Disable DO1 action
do2 High, Low or Disable DO2 action
eventch1 <not required> take snapshots on ch1 while event happen
eventch2 <not required> take snapshots on ch2 while event happen
eventch3 <not required> take snapshots on ch3 while event happen
eventch4 <not required> take snapshots on ch4 while event happen
dura <integer> snapshots taken after event
inter <integer> tenth seconds interval after the event
mdmode <not required> enable motion detection(emode should set)
smode <not required> sequential mode application
sinter <integer> tenth seconds interval for sequential mode
mail upload snapshots by email smethod
ftp upload snapshots by FTP
suffix <not required> FTP file with date and time suffix
Motion detection configuration URL
URL: /cgi-bin/motion.cgi
Name Value Description
cam <1 ~ 4> Video channel number
per <integer> object size percentage
sen <integer> sensitivity percentage