User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Before Getting Started
- Setting up an Ethernet Environment
- Cable Connection
- Powering on VPort 2140 Video Server
- Assigning an IP Address to VPort 2140 Video Server
- Working in a DHCP Server Networking Environment
- Installing the VPort Installation Wizard
- Running the VPort Installation Wizard
- Working in a Non-DHCP Server Networking Environment
- Assigning the IP Address Manually
- Accessing VPort 2140 Video Server for the First Time
- Setting up a Modem Environment
- Mounting VPort 2140
- 3. Accessing VPort 2140 Video Server for the First Time
- 4. System Configuration
- 5. Advanced Applications
- 6. Upgrading System Firmware
- 7. Troubleshooting
- A. URL Commands of Video Server
- Page URL
- System Resource URL
- General Format of Command URL
- System Configuration URL
- Security Configuration URL
- Network Configuration URL
- Video Configuration URL
- Image Quality Configuration URL
- COM 1 Configuration URL
- COM 2 configuration URL
- Camera custom command configuration URL
- Camera preset configuration URL
- Custom camera configuration URL
- Application configuration URL
- Motion detection configuration URL
- Demo configuration URL
- Homepage layout configuration URL
- B. Settings of Supported PTZ Cameras
- C. Camera Control Cable
- D. Time Zone Table
- E. Technical Specifications
- F. Service Information

VPort 2140 User’s Manual URL Commands of Video Server
A-5
Image Quality Configuration URL
URL: /cgi-bin/image.cgi
Name Value Description
cam <1 ~ 4> Video channel number
time <not required> enclose timestamp
text <text string shorter than 15
characters>
enclose caption
color B/W set encoder to monochrome
<other than B/W> set encoder to color
quality Medium lowest resolution
Standard lower resolution
Good normal setting
Detailed higher resolution
Excellent highest resolution
size Half set size to half
Standard set size to standard
Double set size to double
Half x 2 set size to half x 2
Standard x 2 set size to standard x 2
brightness <-5 ~ 5> adjust brightness of image
contrast <-5 ~ 5> adjust contrast of image
hue <-5 ~ 5> adjust hue of image
saturation <-5 ~ 5> adjust saturation of image
preview <not required> not save the parameters
restore <not required> recall the original settings
save <not required> save the parameters
COM 1 Configuration URL
URL: /cgi-bin/serial1.cgi
Name Value Description
RS232 switch COM to RS232 interface
RS485 switch COM to RS485
generic accept generic CGI commands detect
none no drivers
Sony VISCA
Canon VCC1
Canon VCC3
Canon VCC4
DynaDome/SmartDOME
Pelco D protocol
Lilin PIH-7x00
Ernitec
driver
Custom Camera third party PTZ camera