User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Before Getting Started
- Setting up an Ethernet Environment
- Cable Connection
- Powering on VPort 2140 Video Server
- Assigning an IP Address to VPort 2140 Video Server
- Working in a DHCP Server Networking Environment
- Installing the VPort Installation Wizard
- Running the VPort Installation Wizard
- Working in a Non-DHCP Server Networking Environment
- Assigning the IP Address Manually
- Accessing VPort 2140 Video Server for the First Time
- Setting up a Modem Environment
- Mounting VPort 2140
- 3. Accessing VPort 2140 Video Server for the First Time
- 4. System Configuration
- 5. Advanced Applications
- 6. Upgrading System Firmware
- 7. Troubleshooting
- A. URL Commands of Video Server
- Page URL
- System Resource URL
- General Format of Command URL
- System Configuration URL
- Security Configuration URL
- Network Configuration URL
- Video Configuration URL
- Image Quality Configuration URL
- COM 1 Configuration URL
- COM 2 configuration URL
- Camera custom command configuration URL
- Camera preset configuration URL
- Custom camera configuration URL
- Application configuration URL
- Motion detection configuration URL
- Demo configuration URL
- Homepage layout configuration URL
- B. Settings of Supported PTZ Cameras
- C. Camera Control Cable
- D. Time Zone Table
- E. Technical Specifications
- F. Service Information
VPort 2140 User’s Manual Upgrading System Firmware
6-2
3. The program will detect the Video Server. Note that the Upgrade button is grayed out. Use
the Locate the firmware to upgrade navigation tool in the bottom third of the window to
locate the firmware file.
4. Click on the firmware file name to select it, and then click on the Upgrade button in the upper
left corner of the window.