User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Before Getting Started
- Setting up an Ethernet Environment
- Cable Connection
- Powering on VPort 2140 Video Server
- Assigning an IP Address to VPort 2140 Video Server
- Working in a DHCP Server Networking Environment
- Installing the VPort Installation Wizard
- Running the VPort Installation Wizard
- Working in a Non-DHCP Server Networking Environment
- Assigning the IP Address Manually
- Accessing VPort 2140 Video Server for the First Time
- Setting up a Modem Environment
- Mounting VPort 2140
- 3. Accessing VPort 2140 Video Server for the First Time
- 4. System Configuration
- 5. Advanced Applications
- 6. Upgrading System Firmware
- 7. Troubleshooting
- A. URL Commands of Video Server
- Page URL
- System Resource URL
- General Format of Command URL
- System Configuration URL
- Security Configuration URL
- Network Configuration URL
- Video Configuration URL
- Image Quality Configuration URL
- COM 1 Configuration URL
- COM 2 configuration URL
- Camera custom command configuration URL
- Camera preset configuration URL
- Custom camera configuration URL
- Application configuration URL
- Motion detection configuration URL
- Demo configuration URL
- Homepage layout configuration URL
- B. Settings of Supported PTZ Cameras
- C. Camera Control Cable
- D. Time Zone Table
- E. Technical Specifications
- F. Service Information
6
6
Chapter 6 Upgrading System Firmware
Using the VPort Installation Wizard to Upgrade Firmware
1. Open the VPort Installation Wizard, checkmark the box next to the server whose firmware
you wish to upgrade, and then click the Upgrade button.
2. Type in the http port number of the video server whose firmware you wish to upgrade, type
the administrator password in the space provided, and then click Retry.
NOTE: If the password is wrong, a message window will appear asking you to check the FTP
port and password again