User's Manual

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject

to the condition that this device does not cause harmful interference.

Any Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This GSM Mobile Phone meets the government's requirements for exposure

to radio waves. The guidelines are based on standards that were developed

by independent scientific organizations through periodic and thorough

evaluation of scientific studies. The standards include a substantial safety

margin designed to assure the safety of all persons regardless of age or

health.

FCC RF Exposure Information and Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types: M275 (FCC ID: 2ABBS-M275) has also been tested against

this SAR limit. The highest SAR value reported under this standard during

product certification for use at the head is 0.767W/kg and when properly worn

on the body is 0.904W/kg. This device was tested for typical body-worn

operations with the back of the handset kept 1cm from the body. To maintain

compliance with FCC RF exposure requirements, use accessories that

maintain a 1cm separation distance between the user's body and the back

of the handset. The use of belt clips, holsters and similar accessories

should not contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not comply with

FCC RF exposure requirements, and should be avoided.