Use and Care Manual

Status Code Cause Solution

E1 STOP Button has been engaged. Manually restart the mower.

E3 Robot mower is out of the

boundary line perimeter.

Relocate the robot mower in the boundary line

perimeter then manually restart.

E4 No boundary line signal. Check the status of the LED on the charging station.

If it is blinking red, the boundary line is cut or the

boundary wire is not properly connected to the docking

station. Check boundary wire connection.

E5 A collision sensor is triggered. Remove any obstacles or relocate the robot

mower. Then manually restart the mower.

E6 Overcurrent on left propulsion

motor.

Grass too tall and thick? Wheel blocked? If grass is

> 2.6" tall cut with traditional mower. If grass is < 2.6"

adjust height on mower to make sure the cutting can

move without restriction.

E7 Overcurrent on right propulsion

motor.

Grass too tall and thick? Wheel blocked? If grass is

> 2.6" tall cut with traditional mower. If grass is < 2.6"

adjust height on mower to make sure the cutting can

move without restriction.

Information Codes: Displayed on LCD Screen

NOTE: How to Manually Restart - Place the machine within 1m near the boundary line, enter correct

PIN code, then press “start”.

E2 Lift sensor has been triggered. Robot mower lifted? Wheel blocked? Remove

foreign objects then manually restart the mower.

E8 Overcurrent on cutting motor. Grass too tall and thick? Wheel blocked? If grass is

> 2.6" tall cut with traditional mower. If grass is < 2.6"

adjust height on mower to make sure the cutting can

move without restriction.

E9 Faulty battery. Battery malfunction, contact customer service.

E10 Under voltage of battery detected. Place the robot mower back to the charging station

and manually restart the mower. If the issue persists,

please contact customer service.

E11 Tilt sensor triggered. Tilting angle > 30˚? Robot mower is overturned? Place the

robot mower on flat ground and manually restart mower.

All wheels must be on the ground to return to operation.

E12 Wheel spinning without grip. Robot mower stuck in sand or holes? Check the

surrounding lawn, place the robot mower on

flat ground and manually restart the mower.

Information Codes