User manual

X7968r User’s Guide
To configure the WAN IP settings:
 Select/Unselect to enable or disable the Access Configurator option. In case, you
enable the access configurator, enter the value in Access Concentrator.
 Select one of the following options:
z Obtain an IP address automatically.
z Use the following IP address: specify the WAN IP Address.
 Click to Enable NAT.
 Click to Add Default Route
 Click Next.
Configuring the Broadband User Name and Password
Figure 18: Configuring Broadband User Name and Password
To configure the broadband user name and password:
 Enter the user name in Broadband User Name.
 Enter the password in Password and confirm it by entering again in Confirm
Password.
 Specify the network session by selecting Always On, Dial on Demand or
Manually Connect option. You could check the Consider Lanside Traffic Only to
specify the data traffic for Dial on Demand and Manually Connect. You can also
opt to disconnect after a specified period when no user activity is detected. By
default, the option Always On is selected.
 Click Next.
21