User`s manual

Wireless ADSL Router RTA01N User’s Manual

3. From the Basic/Advanced drop-down list, select on

Advanced.

This is the first page displayed each time you log in to the Web

pages. This page contains links to the following pages:

 Addressing; links to the Addressing page that controls your

device’s network address. See Addressing.

 Internet Access; links to the Internet Access page that

controls how your device connects to the Internet. See

Internet Access.

Note

If you receive an error message or the Welcome page is not

displayed, see Troubleshooting Suggestions.

Testing your Setup

Once you have connected your hardware and configured your

PCs, any computer on your LAN should be able to use the

device’s DSL connection to access the Internet.

To test the connection, turn on the device, wait for 30 seconds

and then verify that the LEDs are illuminated as follows:

Table 1. LED Indicators

LED

Behavior

Power

Solid green to indicate that the device is turned on. If this

light is not on, check the power cable attachment.

Ethernet

Flashing on/off while the device is booting. After about 10-

15 seconds, solid green to indicate that the device can

communicate with your LAN.

ADSL

Flashing on/off while data is being transmitted. Solid green

to indicate that the device has successfully established a

connection with your ISP.

Internet

Flashing on/off while data is being transferred. Solid green

when a valid IP address has been assigned to the device

by the ISP.