User`s guide

6
You may either connect your computer to the router using an Ethernet cable if they are
sufficiently close to each other or by means of a wireless network. Furthermore, you can
simultaneously have certain items of equipment connected to the router using the Ether-
net cable and others as portable through the wireless network.
You can use the wireless network as long
as your computer is equipped with a wire-
less adapter installed or this is integrated
into your equipment. Your router has
enabled the wireless network by default.
If it would not be enabled, the first step
would be to enable the wireless network
for your router. This is done by pressing
the button Wifi/WPS located at the back
of the router within four seconds (press-
ing it during eight seconds would activate
the WPS process). The Wifi/WPS indi-
cator will light up in green and will blink
when navigating.
The configuration parameters by default
for your wireless network are shown on
the label at the bottom of your router.
The next step is to configure the compu-
ters on your wireless network in accordan-
ce with your router’s wireless parameters.
A. Connection using wireless network
4. Connecting the computer to the router. Two options are available
Start using your VDSL...
For further information please refer to section 3.5 of the user’s manual on the documentation CD.
DSL
Reset
Eth1 Eth2 Eth3 Eth4
USB Wifi/WPSON/OFF
12V 1A
Wifi/WPS
DSL
Reset
Eth1 Eth2 Eth3 Eth4
USB Wifi/WPSON/OFF
12V 1A