User`s manual

BHS-RTA
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
U
U
s
s
e
e
r
r
’
’
s
s
M
M
a
a
n
n
u
u
a
a
l
l
C
C
o
o
d
d
e
e
:
:
B
B
H
H
S
S
_
_
R
R
T
T
A
A
_
_
A
A
D
D
V
V
_
_
U
U
S
S
E
E
R
R
_
_
M
M
A
A
N
N
U
U
A
A
L
L
E
E
d
d
1
1
.
.
0
0
Page 60 de 67
3.4.3.2 Services
In the Access Controls page, click Services. The page shown in the following figure appears.
Figure 86
In this page, you can enable or disable the services that are used by the remote host. For example, if telnet
service is enabled and port is 23, the remote host can access the device by telnet through port 23. Normally,
you need not change the settings.
Select the management services that you want to enable or disable on the LAN or WAN interface. Click Apply
to apply the settings.
Note:
If you disable HTTP service, you cannot access the configuration page of the device any more.
3.4.3.3 IP Address
In the Access Controls page, click IP Address. The page shown in the following figure appears.
Figure 87
In this page, you can configure the IP address for access control list (ACL). If ACL is enabled, only devices
with the specified IP addresses can access the device.
Tick Enable Access Control Mode to enable ACL.