User`s manual

BHS-RTA
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
U
U
s
s
e
e
r
r
’
’
s
s
M
M
a
a
n
n
u
u
a
a
l
l
C
C
o
o
d
d
e
e
:
:
B
B
H
H
S
S
_
_
R
R
T
T
A
A
_
_
A
A
D
D
V
V
_
_
U
U
S
S
E
E
R
R
_
_
M
M
A
A
N
N
U
U
A
A
L
L
E
E
d
d
1
1
.
.
0
0
Page 28 de 67
Field
Description
example, the encryption password) are provided by the CPE in WPS
negotiation. When Unconfigured state is selected, wireless
parameters are provided by the connecting user end (for example,
PC).
Push Button
Press the button, the CPE will connect the station automaticlly.
Input Station PIN
You need to enter a pin the station which mode is Enrollee
Generate. Press the button to connect the other with the pin.
When Registrar mode is chosen, the following figure appears. In this condition, only PIN button can be
used.
The following table describes the parameters of this page.
Field
Description
Generate PIN
Press the button to generate a pin used by the AP and the station.
PIN Station
Press the button to connect the station with the pin.
WPS Session Status
Display the session status.
3.3.2 Port Forwarding
This function is used to open ports in your device and re-direct data through those ports to a single PC on
your network (WAN-to-LAN traffic). It allows remote users to access services on your LAN, such as FTP for file
transfers or SMTP and POP3 for e-mail. The device accepts remote requests for these services at your global
IP address. It uses the specified TCP or UDP protocol and port number, and redirects these requests to the
server on your LAN with the LAN IP address you specify. Note that the specified private IP address must be
within the available range of the subnet where the device is in.
Choose Advanced > Port Forwarding. The page shown in the following figure appears.