User`s manual

BHS-RTA
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
U
U
s
s
e
e
r
r
’
’
s
s
M
M
a
a
n
n
u
u
a
a
l
l
C
C
o
o
d
d
e
e
:
:
B
B
H
H
S
S
_
_
R
R
T
T
A
A
_
_
A
A
D
D
V
V
_
_
U
U
S
S
E
E
R
R
_
_
M
M
A
A
N
N
U
U
A
A
L
L
E
E
d
d
1
1
.
.
0
0
Page 16 de 67
The following table describes the parameters in this page.
Field
Description
Enable Wireless
Select this to turn Wi-Fi on or off.
Enable MultiAP
Isolation
Select this to turn MultiAP isolation on and off.
Wireless Network
Name (SSID)
The Wireless Network Name is a unique name that identifies a network.
All devices on a network must share the same wireless network name in
order to communicate on the network. If you decide to change the
wireless network name from the default setting, enter your new wireless
network name in this field.
Visibility Status
You can select Visible or Invisible.
Country
Select the country from the drop-down list.
Control Sideband
Choose the channel selection mode as Upper or Lower.
Wireless Channel
Select the wireless channel from the pull-down menu. It is different for
different country.
802.11 Mode
Select the appropriate 802.11 mode based on the wireless clients in your
network. The drop-down menu options are 802.11b, 802.11g,
802.11n, 802.11b/g, 802.11n/g and 802.11b/g/n.
Band Width
Select the appropriate band of 20M, 40M or 20M/40M from the pull-
down menu.
Click Apply to save the settings.
3.2.3.2 Wireless Security
In the Wireless page, click Wireless Security. The page shown in the following figure appears. Wireless
security is vital to your network to protect the wireless communication among wireless stations, access
points and wired network.
Note:
Enable Wireless before configuring the wireless security settings in this page. Refer to 3.2.3.1
Wireless Basic.