Manualshelf

User`s guide

ManualsBrandsMoveman ManualsGadgetsSSP-100
12345678910
Typical scenario in a PC
l IDE connector 1
F1
-
Master
d
hard disk drive (do not change!)
-
Slave
c3
empty
l IDE connector 2
r?
-
Master
~3
CD-ROM drive
-
Slave
c3
empty
l
Set jumper on IDE/CF Internal Drive “slave”
~3
remove jumper
l
Remark: Keep the jumper for future use.
l
Connect IDE/CF Internal Drive to IDE connector 2
Make sure to know jumper settings (master
/
slave) of all IDE devices. Then
determine appropriate setting for IDE/CF Internal Drive. Most importantly you
should avoid setting 2 masters or 2 slaves on
1
IDE connector. In this case the
PC may not run correctly.
3. Jumper setting IDE/CF Internal Drive
/
pin
I
Master
setting
Slave setting
Pin
I