User Manual

Ultra R4000 Service Application
24 25
To delete all learned functions at one time, use the procedure below.
1. Press and hold the CLEAR button (the current component button lights). Then press and
hold the ON/OFF button (component button light turns off for 3 seconds, flashes, turns
on and off) while continuing to hold the CLEAR button.
2. Release both buttons (current component button turns on).
3. Press any component button to delete all learned functions in all modes. The RCU
automatically exits this clearing mode.
Note: Pressing the CLEAR button while in this mode will not delete the learning functions,
but it will exit this delete mode.
Music Mode
Music mode is a revolutionary new way for you to search through and play your favorite
songs that you have already setup on your Windows PC. It links directly to your
Windows Media Player Audio library so that you can browse through your audio files and
listen to your music without going to your computer.
Note: This mode of the RCU is intended for use on the Windows operating system using
the Windows Media Player application (version 10 or higher). Operation on other operating
systems has not been verified.
Ultra R4000 Service Application
The RCU comes with a software application that runs in the background (as a “service”)
on the computer (PC) and interfaces to the Windows Media Player music database. The
application communicates the music database information to the RF transceiver attached
to the computer. The information is then transmitted via RF to the RCU and displayed on the
display. The Ultra R4000 Software Service Application or “Music Software service”
is required for operation of the Music display. This Software service is provided via an
installation CD.
This application can be enabled/disabled manually by the user. The application is set
to “enabled” by default (upon system boot). Disabling the service has no effect on normal
RCU operation (TV, PC, CAB/SAT, and AUX modes), but will make the display inoperable.
3) On the RCU, press and release the button where you want to store the new function (the
component button turns off and then back on; a short flash).
Note: If you press an invalid button on the remote, the device mode button flashes 4 times
to alert you. You’ll have to repeat step 3.
4) Position the source remote facing the bottom of the RCU no more than 2 inches apart.
Press and hold the button of the source remote that has the functionality you are
recording. Keep pressing the button until the RCU device mode button light turns off and
back on (the source function has been saved to the TV mode on the RCU).
Note: If all device mode buttons flash 4 times, the function wasn’t learned. Try again
starting with Step 3.
5) The RCU remains in the “learning mode” so you can continue adding functions to
different buttons by repeating steps 3 and 4.
6) Press CLEAR to exit the learning mode.
Clearing an Individual Learned Function
To delete a learned button function, use the procedure below.
1. Press and hold the component mode button (the component button lights). Then press
and hold the CLEAR button for 3 seconds. Hold both buttons depressed until the
component mode button flashes.
2. Release both buttons. The component mode button turns on indicating that the RCU is
now in the Clear Learned Function mode for that component.
3. Press and release the button where learning is to be cleared. The component mode
button blinks off then back on indicating that the function was cleared successfully.
4. Repeat Steps 1 through 3 until all the buttons’ learned functions have been cleared.
Note: If an invalid button is pressed, the component mode button flashes 4 times, the
selected component button stays on, and the RCU remains in Clear Learned Function
mode. Repeat Step 3 to continue the clearing process.
5. Press the CLEAR button to return the RCU to normal operation.
Learning (continued) Deleting All Learned Functions