User Manual

18 19
RF Receiver & Synchronization
Communication between the RCU and the PC is done via an RF transceiver which is plugged
into a standard USB port in the PC. In order for this to work, you need to synchronize, or
“bind” your remote and PC. See below for the binding procedure.
Setting Up & Synchronizing The
Remote & The PC
After inserting the batteries in the remote control unit,
1. Hold the remote in close proximity to the PC.
2. Press the CONNECT button on the RF Dongle transceiver which is plugged into
the PC USB port.
3. Press the CONNECT button on the underside of the RCU.
4. The Display screen on the RCU will indicate a successful connection.
5. If a successful connection is not made, repeat steps 1 - 3
Receiver Installation
The RCU requires a USB RF transceiver be plugged into a USB port in the PC in order to
access RF and gyro functions. The USB extension cable can be used to maximize the range
of the RCU by placing the USB RF transceiver away from other electrical components. A
USB RF transceiver does not need to be plugged in to use the IR remote functions. See the
diagram below.
USB Features
• Connects to PC via standard USB 2.0 connection
• PC operating systems supported: Windows Vista, Windows XP MCE, and Windows XP
• LED to indicate bind sequence and radio activity
• Connect button, pen-push type
USB Compatibility
The transceiver uses a standard USB Type A connector for connection to any standard USB
port of a computer. The transceiver is a certified USB compatible 2.0 device, running at low
speed. It is certified to run on Windows Vista, Windows XP MCE, and Windows XP.
This transceiver is compatible with the following Gyration products:
Ultra R4000 (The Music Service and Music Display functions of this remote require use of
the included Ultra 4000 RF Receiver to fully function)
Gyration Go Mouse
Gyration Go Mobile keyboard
Gyration Go Full size keyboard
Gyration Media Center Universal Remote Control
Gyration GyroTransport
Transceiver Compatibility
Matrix with Gyration Products