User's Manual

RF RECEIVER
Symptom
Computer does not recognize
data input
Keyboard and Receiver not
synchronized
Perform a Connect/Connect sequence (see
Setting Up and Synchronizing the Keyboard
and the Gyration RF Receiver on page 1).
Possible radio
interference
Move receiver away from other electronic
devices (e.g., monitor, speakers, radio, etc.).
Keyboard is off Power it on (see Powering the Keyboard On
and Off on page 4).
Dead batteries Replace batteries
Possible radio
interference
Keystrokes are not consistently
recognized
Move receiver away from other electronic
devices (e.g., monitor, speakers, radio, etc.).
Reason Solution
Troubleshooting
76
Connect Button
Pressing the Connect button for two seconds puts the RF receiver into Connect
Mode, allowing you to synchronize a device with the receiver. If the receiver is
not manually taken out of Connect Mode, it will automatically return to Normal
Mode after one minute.
Status/Connect LED
The Status/Connect LED lights display useful information about the modes of
operation and the connection between the receiver and transmitter(s). Its
various states are:
STATUS LED CONNECT LED
• Remains off when the receiver is operating in
Normal Mode and no devices are transmitting.
• Flickers rapidly when the receiver is operating
in Normal Mode and a synchronized device
is transmitting.
• Blinks rapidly (one blink per second) when
the receiver is in Connect Mode and is
awaiting a Connect instruction from a device.
• Lights solid when connected to a device.
GC1105CKM_NA_IB_REVA_K6.qxd 2/11/05 12:51 PM Page 10