User's Manual

12
Mouse LED comes on when activate
button is pressed, but receiver is
unresponsive
Mouse and Receiver not
synchronized
Perform a Connect/Connect sequence (see
Setting Up and Synchronizing the G.O. Air Mouse
and the Gyration RF Receiver on page 4).
When using in air, cursor is visible but
shows no movement
Gyroscope not activated
Batteries are low
Radio interference
Squeeze or double-click trigger on bottom of
mouse.
Cursor movement is choppy or erratic Move receiver away from other electronic devices
(i.e., monitor, speakers, radio, etc.).
When pressing the Activate button, the
LED on the mouse is flashing
Recharge battery pack or replace (see Installing
and Charging the Batteries on page 1).
Batteries are dead
Mouse is off
When pressing the Activation Trigger,
the LED on the mouse is off
Recharge battery pack or replace (see Installing
and Charging the Batteries on page 1).
Speed or acceleration not
set properly
Cursor moves too fast or too slow Change the cursor tracking speed in the mouse
control panel.
Sensor may require
recalibration
Cursor drifts on the screen Place the mouse on the desk for 4 or more
seconds to steady the cursor.
Dirty contactsMouse LED does not flash in charging
cradle and mouse does not charge
Clean the contacts on bottom of mouse.
Mouse used on dark-colored
surface
Inadequate battery life Use mouse on light-colored surface to minimize
battery drain.
End-of-life battery Replace battery
Power it on (see Powering the G.O. Air Mouse On
and Off on page 5).
Symptom Reason Solution
Troubleshooting
GC1005M_NA_IB_REVA_K6.qxd 2/11/05 11:33 AM Page 12