User Manual

24
1. Start your PIXIO robot into the pairing mode
Checkthatalldevices(robots,watchesandbeacons)areOFF.
PressandholdthezoomINbuttononthemasterrobot,thenpressbriey
Release the zoomINbuttonwhenthegreenandredlightsblinktogether.
The master robot enters into the pairing mode and the green light ashes twice
intermittently.DonotturnOFFthemasterbeforepairingalldevices.
Youmustpairatleastonewatchand3beaconstothemaster.
Youcanaddupto15additionalrobots(slaves)andlmupto16people.
Pairing procedure: pair your devices (robots, watches and
beacons)
- if you have a single robot and several watches, your robot will become the master.
- if you have several robots, you have to choose one to become the master.
While lming, the master robot should always be ON. The master collects data from the other devices to
run MULTI-USER mode.
1.Pressonhold
ZoomINbutton
3.ReleaseZoomIN
buttonwhenthe
greenandredlights
blinktogether
2.BrieflypressPOWER
ON