User Manual

11
Start tracking
SwitchONthecamera.
AdjustthetripodhorizontallyandsettheTILTangleofthecameraby
screwingmoreorlessthescrewattherearoftherobot.
Check that the watch is OFF. SwitchONthePIXIOrobotbypressingthe
power button attherearoftherobotuntilthegreenlightstarts
toash.
Byrotatingthetripod,orusingrobotbuttons and , place the beacon n°1 at the center of the
camerascreen. Whatisimportantis theright-leftpositionof thebeacon.Usethe manualZOOMonthe
cameratoimprovetheprecision.A50cm(20inches)precisionisenough.
RemainintheareaandswitchONthewatchbypressing itsstarterbuttonuntilthegreenlightturnsON.
Thesysteminitializesduringabout10to30seconds.WhenthewatchLEDisblinkingregularly,theinitialisation
isnishedandtherobotistrackingthewatch.
unscrew to
decreasetheTILT
angle
screw to increase
theTILTangle
Beaconn°1