Specifications

STEP
5
MOUNTING AND SETUP
• Select a location for the Game Cam II. This might be facing
a feeder, a trail through the woods, or another area
frequented by animals to be photographed. Mount the Game
Cam II on a tree or post at about 2-3 feet above the ground
using a bungee cord through the metal eyelets at back of the
case.
• Turn on the AIM LIGHT (refer to STEP 4, above).
• To test setup, a person can move into the Game Cam II
operating range (refer to the Specifications section of this
document for details) and note when AIM LIGHT
illuminates. Adjust mounting of Game Cam II as necessary.
• When camera is properly aimed, turn AIM LIGHT OFF for
camera concealment and to preserve battery life.
• Turn the camera on by sliding the switch under the lens to
the right
• Securely close and latch the door.
• Game Cam II is now ready for operation.
Section B - Game Cam II
®
Camera Details
Mid-roll Rewinding
The camera can rewind the film mid-roll for removal and processing. Using a soft
pointed object, press the rewind button on the top of the camera as shown. To avoid
damaging buttons, apply only light pressure
and do not use a sharp object.
Top Camera Buttons
The two additional buttons on the top of the
camera, Flash and Photo Delay, should not be used
. If accidentally activated,
pressing the button again will turn them OFF (as indicated on the top display).