Specifications

Section A - Game Cam II
®
Quick Start Instructions
In addition to the supplied equipment, you will need:
 Rechargeable or alkaline 6-volt spring-top battery
 35mm camera film – 800 speed recommended for best results
 Bungee cord for mounting Game Cam II
STEP
1
BATTERY INSTALLATION
Open Game Cam II case as illustrated
above. To install the 6-volt battery,
attach black alligator clip to (-) terminal
of battery and red alligator clip to (+)
terminal. Place battery in case as
shown. DO NOT PUT BATTERIES
INTO CAMERA.
STEP
2
FILM LOADING
• Lift camera from Game Cam II case and turn over.
• Slide back cover latch down to open
camera back.
• Turn the camera on by sliding the switch
under the lens to the right as shown.
• Insert film in chamber and pull film to
film stop as shown.
• Close the back
cover. It will close
with a “click”.
• The film will automatically
advance until display at top of
camera reads “1”; if it flashes “0”, film is
loaded incorrectly and must be reloaded according to same
directions. Turn camera off until Game Cam II is mounted.
For picture number to be read correctly,
top display must be read when facing back of camera
Camera
6V Battery
Low Battery
Indicator
Configuration
Switches