Operation Manual

6
Fit the appropriate plug according to the ins-
tructions in paragraph "Fitting a plug". With
alternative plugs a 15 amp fuse must be fitted
either in the plug or adaptor or at the main fuse
box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter ‘E’ or by the
earth symbol or coloured green or green
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter ‘N’ or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter ‘L’ or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the requirements
of the EEC Directive (89/336/EEC).
- Your kettle must be used only with the lid
closed, and with its associated base (for
kettles with a base).
- The use of multiple sockets and/or mains
extension leads is not recommended.
- Do not place the appliance, the base, the
power cable or the plug in water or any other
liquid.
- Do not use abrasive pads for cleaning.
- To remove the anti-scale filter, take the kettle
off its base, and leave it to cool. Never
remove the filter when the appliance is full
of hot water.
- Our guarantee excludes kettles which do
not work or which work badly, due to the
absence of anti-scaling.
- Never use any anti-scaling method other
than that recommended.
- Do not use the kettle if the power cable or
the plug is damaged. In order to avoid all
danger, you should have the faulty item
replaced by a Moulinex approved service
centre.
English
Thank you for choosing an appliance from the
Moulinex range which is intended exclusively
for the heating of water.
Safety recommendations
- Use your kettle only for the heating of drinking
water.
- Place the kettle and its lead well to the back
of the worktop.
- Keep the kettle and the power cable away
from any source of heat, from any wet or
slippery surface, and from sharp edges.
- Do not fill to above the max level or below
the min level. If the kettle is over-filled, boiling
water may be ejected.
- Do not open the lid when the water is boiling.
- Check that the electrical installation is in
conformity with currently-applicable stan-
dards, and compatible with the power and
the voltage indicated underneath your model.
- Connect the kettle only to a socket with an
earth incorporated.
Any connection error will nullify the
guarantee.
Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this appliance
is supplied complete with a plug incorporating
a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS 1363
type, and therefore do not accept the plug
connected to this appliance, cut off the plug if
moulded type or remove the plug if connected
by screw terminals.
When the plug is a moulded type and this is cut
off from the appliance, the connected wires are
a shock hazard. Do not under any
circumstances connect a cut off plug into the
electrical socket outlet. The cut off plug must
be disposed of in a safe manner that prevents
any form of connection.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Bouilloire commune.PM6.5 15/10/04, 9:476