Operation Manual

11
double-sided metal tray (E9bis). Blades A
and B, in this case, are obtained by
turning the tray over (blade G cannot be
mounted in this case).
Slide the blades (A, G, H) into the blade
holder disc (E9), place the blade holder
(E8) on the axis of the bowl (E), then
place the blade holder disc (E9) on the
blade holder (E8). Put the reducer (E6)
on the lid (E3).
Place the lid (E3) on the bowl and lock it.
Set the motor unit (A1) in position on
the lid. Turn on.
Introduce the food through the feeder
tube and push them down using the
pusher (E2), never with your fingers or
any other utensil.
To dismantle, press the eject button (E7)
to remove the motor unit (A1) from the
reducer (E6) before removing the lid.
Unlock (E7) the lid (E3) to access the food.
Carefully remove the blade holder disc
(E9) and the blade holder (E8) before
removing the food. Then carefully remove
the blades (A, G, H) from the blade holder
disc (E9).
Blade A (Grater): carrots, cheese, celery,
etc.
Prepare a maximum of 1000g of food at a
time (but not meat or cold meat products).
Blade H (Slice): raw sliced potatoes for
gratins, carrots, cucumbers, etc.
maximum 800 g.
Blade G (Parmesan): Parmesan, raw
potatoes.
Unplug the appliance, remove the
accessories.
The reducers (E6, F3 and the whisk
holder C1) as well as the motor unit (A1)
are not dishwasher proof; you can wipe
them with a damp sponge.
All the other accessories are dishwasher
proof. Place the blender shaft (B1)
with the blade facing upwards in the
Cleaning
dishwasher. Do not use abrasive
sponges or objects that contain metal
parts.
Never plunge the motor unit (A1) into
water. Wipe it down with a dry or very
slightly damp cloth.
In the event that your accessories
become colour stained by foods such as
carrots, oranges, beetroot etc rub over
them immediately after use with a cloth
dipped in a little sunflower oil and then
clean them as usual.
Handle the blades E4, E5, F2 and I2
or blades A, G, H with extreme care;
they are very sharp.
Start by checking the power cord and
plug, then:
Check that the lid (E3) to your
multifunction bowl is properly locked. If it
is not properly locked your motor unit
(A1) will not be able to make your
multifunction bowl work because the
reducer drive system (E6) will not
operate.
Check whether the appliance’s safety
system has not been activated, by
processing too much mixture or by using
the appliance for too long. If it has, leave
the appliance to cool down for around
30 minutes.
If the lid does not lock properly, press the
unlocking button (E7) on the reducer (E6)
before locking it again.
Refer to the “Usage” paragraph for
assembly instructions.
You have carefully followed all these
instructions, and yet your appliance still
does not work?
Please contact our Helpline:
0845 602 1454 - UK
[phone] - Ireland
or consult our website :
www.moulinex.co.uk
What do I do if my appliance
doesn’t work?