User Manual

PRESETS
50
STAND-ALONE MIXER
Choose the Stand-alone mixer preset to use the 8D
as a mixer. Doing so routes all physical inputs to the
mixer, with the mixer’s main mix bus going to
Headphone Out L-R. If needed, you can use the
routing grid to also send the main mix to any
output pair, or even multiple output pairs.
The Monitor bus is set up as a solo bus.
To control the mixer (with the web app), you have
several options. You can connect a computer to the
8D using USB, Ethernet, or Wi-Fi, as explained in
“Setup for web app control” on page 37. Figure 5-2
below shows the Wi-Fi scenario. Note that you can
control the mix from multiple Wi-Fi devices.
Figure 5-2: Using the 8D as a stand-alone mixer. This example
demonstrates how you can control the mixer from several Wi-Fi
devices.
INTERFACE + MIXER
Choose the Interface + Mixer preset to use the 8D
as both an audio interface and mixer, simulta-
neously. This preset is identical to the Audio
Interface preset, except that all From Computer
channels are also routed to the 8D’s on-board
mixer, which mixes them to the Headphone Out
L-R. The on-board mixer mixes all of the following
sources:
■ The 8D’s AES-EBU inputs
■ The 8D’s S/PDIF inputs
■ From Computer channels 1-10 (USB channels
from the host computer)
The Monitor bus is set up as a solo bus.
In this scenario, you can control the mixer from the
MOTU Pro Audio Control web app running on the
computer. You can also run the web app from
wireless devices on the same Wi-Fi network as the
laptop.
Figure 5-3: Using the 8D as an audio interface and mixer, simulta-
neously.
Airport
or any other Wi-Fi router
Ethernet
cable
Wi-Fi devices
Laptop (optional) Tablet Smart
phone
Local inputs plus network inputs
Main
Mix
Aux
Mix
Group
Mix 1
Group
Mix 2
Laptop
Audio inputs from stage, studio, etc.
Main
Mix
Aux
Mix 1
Aux
Mix 2