User`s guide

INSTALLING THE 828MKII HARDWARE
20
A TYPICAL 828MKII SETUP (NO MIXER)
Here is a typical 828mkII studio setup. This rig can
be operated without an external mixer. All mixing
and processing can be done in the computer with
audio software. During recording, you can use the
828mkII’s CueMix™ DSP no-latency monitoring
to listen to what you are recording via the main
outs, headphone outs, or any other output pair. You
can control monitoring either from the front panel
or from the included CueMix Console software.
The two front-panel guitar/mic inputs can be
routed to outboard effects processor, such as a
compressor, EQ or reverb, via the rear panel sends.
ADAT
S/PDIF
DAT deck
ADAT optical
quarter-inch
analog outs
synthesizer
monitors
guitar
(with or without a
modeling amp)
quarter-inch analog outs
synths, samplers, effects units, etc.
sends to
FX unit
(in rack
below)
Figure 4-5: A typical 828mkII studio setup.
headphones
other outputs (stage
monitors, surround
monitors, etc.)
MIDI IN/OUT
foot
switch
PC
828mkII
front panel
828mkII
back panel
Compressor, reverb or
other outboard gear
mic
FireWire
!828 Manual/Win Page 20 Tuesday, May 27, 2003 1:36 PM