Datasheet

Ip251_02b_oi_e.doc / Dez-15 Page 11 / 28
6. Extended Functions with PC Setup
For normal use with standard applications, the unit is ready to work after correct wiring and
setting of the DIL switches. In this case, the subsequent sections are not relevant.
With use of a PC however, you have full access to useful complementary functions and tests as
shown subsequently. For this you will need the PC operator software OS3.x which is available
for free download from
www.motrona.com
Connect your PC to the converter, using a serial RS232 cable like shown in section 4.6. of this
manual. Then run the OS3.x software and you will see the following screen:
In case your text and color fields remain empty and the headline says „OFFLINE“, you must
verify your serial settings. To do this, select „Comms“ from the menu bar.
Ex factory, all motrona units use the following serial standard settings:
Unit No. 11, Baud rate 9600, 1 start/ 7 data/ parity even/ 1 stop bit
If the serial settings of the unit should be unknown, you can run the
„SCAN“ function from the „TOOLS“ menu to find out.