Instructions

Ax350_06a_oi_e.docx / Aug-19 page 42 / 78
Continuation „Command Menu”:
INPUT 1 CONFIG
This parameter defines the switching characteristics of the input “Ctrl. In 1”.
0
ACTIVE LOW
Active at „LOW“ (static)
1
ACTIVE HIGH
Active at „HIGH“ (static)
2
RISING EDGE
Activate at rising edge (dynamic)
3
FALLING EDGE
Activate at falling edge (dynamic)
INPUT 2 ACTION
This parameter defines the function of the input “Ctrl. In 2”.
See parameter INPUT 1 ACTION
INPUT 2 CONFIG
This parameter defines the switching characteristics of the input “Ctrl. In 2”.
See parameter INPUT 1 CONFIG.
INPUT 3 ACTION
This parameter defines the function of the input “Ctrl. In 3”.
See parameter INPUT 1 ACTION.
INPUT 3 CONFIG
This parameter defines the switching characteristics of the input “Ctrl. In 3”.
See parameter INPUT 1 CONFIG.
Display Menu
Parameter changes become active only after closing the menu selection.
START DISPLAY
This parameter defines the start display after switching on the device.
0
SINGLE
Single-line display
The source must be defined in SOURCE SINGLE
1
DUAL
Two-line display
The sources must be defined in SOURCE DUAL TOP / DOWN.
2
DUAL WITH UNIT
Two-line display with units
The sources must be defined in SOURCE DUAL TOP / DOWN.
3
LARGE
Large display (only with active parameter "LARGE DISPLAY")
The source must be defined in SOURCE LARGE
4
QUICKSTART
Display with quick start function. (Only with option AO, CO, RL)
5
MINIMUM/MAXIMUM
Display with actual / minimum / maximum values of input 1 and input 2