Owner's manual
info@motorvac.com www.motorvac.com
9
Transmission Service Procedure
Follow the steps below to connect the unit to the vehicle’s transmission cooler lines.
Make sure the vehicle has at least 1/8 tank of fuel before beginning this process.
Warning! It is not necessary to empty the waste tank before beginning an exchange. If beginning an
exchange with uid in the waste tank ensure that there is less uid in the clean tank than the remaining
capacity of the waste tank. Failure to do so will result in waste tank overowing!
1. Add the correct amount of automatic transmission uid into the TRANSTECH’S clean tank reservoir.
See chart:
NOTE: Quantity of uid used per vehicle may vary depending on the condition of the uid in the
transmission being serviced. Trucks and Step Vans may have a larger transmission, therefore may use
more uid than specied in this chart.
2. Start engine, let run until it reaches operating temperature, turn engine OFF.
IMPORTANT
Do not perform the transmission service if the vehicle’s engine oil or coolant level is low. If
necessary, add motor oil and/or coolant.
Do not perform service if new transmission uid is below 50 degrees Fahrenheit.
WARNING
Flammable Liquid can squirt out of pressurized lines when connecting or disconnecting.
Verify that engine and machine are both off before connecting or disconnecting cooler
lines or adapters.
Wear safety goggles.
Wear chemical resistant gloves when connecting or disconnecting ttings and adapters.
Wrap a shop towel around pressure ttings and adapters when disconnecting.
Avoid exposure to ames, sparks, hot engine parts, and other ignition sources.
Explosion or ame or exposure to ammable liquid and vapors can cause injury.
APPROXIMATED FLUSH CHART
4 Cylinder vehicle 10-12 quarts
6 Cylinder vehicle 12-14 quarts
8 Cylinder vehicle 14-16 quarts