Specifications

A-27
A.7 Emergency Log Entries
IP Filter Module LOG_DEBUG Protocol mismatch
IP Filter Module LOG_DEBUG direction mismatch[incoming/outgoing]
IP Filter Module LOG_DEBUG Hash entry pointing to NULL
IP Filter Module LOG_DEBUG Packet Source IP [ip address]
IP Filter Module LOG_DEBUG Packet Destination IP [ip address]
IP Filter Module LOG_DEBUG Packet protocol [protocol number]
IP Filter Module LOG_DEBUG Packet port [port number]
IP Filter Module LOG_DEBUG Packet direction[incoming/outgoing]
IP Filter Module LOG_DEBUG Default Action
IP Filter Module LOG_DEBUG Action [Allowing/Dropping] packet
DynDNS Module LOG_DEBUG No Change in Hostname and WAN IP
DynDNS Module LOG_DEBUG DynDNS: Duplicate record
DynDNS Module LOG_DEBUG [function]: Adding Service and Interface record DONE
DynDNS Module LOG_DEBUG “DynDNS Status: [Status] IP [IP address], Hostname [hostname] “
System Component Debug Level Log Message
Cell Controller Module LOG_EMERG Caught Signal [Number] Aborting with core dump!
Cell Controller Module LOG_EMERG Assertion failed. Aborting with core dump!
Cell Controller Module LOG_EMERG bind failure: address in use. Check
Cell Controller Utility
Module
LOG_EMERG Assert Fail File %s Line [Number]; Exiting\n file
Rogue AP Detection Module LOG_EMERG memory allocation failure!
Rogue AP Detection Module LOG_EMERG Memory allocation failure!
Security Policy Module LOG_EMERG Config read failure. File: %s Line: [Number] \
Security Policy Module LOG_EMERG Couldn't init Security Policy for WLAN [Number] reverting to defaults i+1
AP2AP Beaconing LOG_EMERG memory allocation failure!
System Component Debug Level Log Message