Specifications

A-11
Address Lookup Table Module LOG_ERR cfg radio type [Number] not allowed rtype
Address Lookup Table Module LOG_ERR rfport list is full
Address Lookup Table Module LOG_ERR wlan [Number]: addr1 = [MAC_ADDR] addr2 = [MAC_ADDR] wlan_idx
Cell Controller Module LOG_ERR Error [Number] initing sig handlers errno
Cell Controller Module LOG_ERR Error [Number] initing stats.cpp errno
Cell Controller Module LOG_ERR no shmem!!
Cell Controller Utility Module LOG_ERR Get_Mem: errno [Number] opening %s errno str
Cell Controller Utility Module LOG_ERR Get_Mem: errno [Number] reading file %s errno str
Cell Controller Utility Module LOG_ERR Get_Mem: error parsing file %s str
EAP Module LOG_ERR Unable to read ESS from config
EAP Module LOG_ERR Unable to read Sys-Name from config
Kerberos Client Module LOG_ERR krb: error [Number] in decrypt_as_reply) retval
Kerberos Client Module LOG_ERR krb: error [Number] in stash_as_reply) retval
Kerberos Client Module LOG_ERR krb: error [Number] in verify_as_reply) retval
Kerberos Client Module LOG_ERR krb: error [Number] reported by decode_krb5_error) retval
Kerberos Client Module LOG_ERR krb: error [Number] reported by encode_krb5_as_req) retval
Kerberos Client Module LOG_ERR krb: error [Number] reported by krb5_obtain_padata) retval
Kerberos Client Module LOG_ERR krb: socket bind error. errno [Number] errno
Kerberos Client Module LOG_ERR krb: socket creation error. errno [Number] errno
Kerberos Client Module LOG_ERR krb: socket recv error. fd [Number]. errno [Number] fd errno
Kerberos Client Module LOG_ERR krb: socket send error on fd [Number]. errno [Number] kdc_fd errno
Kerberos Client Module LOG_ERR krb5: error [Number] reported by
Kerberos Proxy Module LOG_ERR krb5: socket rcv error. errno=[Number] errno
Kerberos Proxy Module LOG_ERR krb5: socket send error. errno=[Number] errno
Kerberos Proxy Module LOG_ERR krb5: socket send error. errno=[Number] errno
Kerberos Proxy Module LOG_ERR Socket bind error. errno: [Number] errno
Kerberos Proxy Module LOG_ERR Socket creation error. errno: [Number] errno
NTP Client Module LOG_ERR ntp enabled but no valid IP address configured
NTP Client Module LOG_ERR ntp rsp [Number] bytes) from [IP_ADDR] is too small
NTP Client Module LOG_ERR ntp:error reading configuration
System Component
Debug
Level Log Message