Specifications
A-3
Encryption Key Exchange
Module
LOG_INFO [Pairwise Transient Key] Unable to get free CC buffer
Encryption Key Exchange
Module
LOG_INFO [Pairwise Transient Key] Group rekey after %u seconds gk_timeout
RADIUS Module LOG_INFO rcvd access-accept from [IP_ADDR] for [MAC_ADDR]
RADIUS Module LOG_INFO rcvd access-reject from [IP_ADDR] for [MAC_ADDR]
RF Port Module LOG_INFO Radio [MAC_ADDR] acs done ch=[Number]
RF Port Module LOG_INFO Radio [MAC_ADDR] acs in progress addr
RF Port Module LOG_INFO Radio [MAC_ADDR] adopted addr
RF Port Module LOG_INFO Radio [MAC_ADDR] inactive prtl_ptr->addr
RF Port Module LOG_INFO Radio [MAC_ADDR] removed prtl_ptr->addr
RF Port Module LOG_INFO Radio [MAC_ADDR]:non-acs status has no channel
RF Port Module LOG_INFO RF Port [MAC_ADDR] removed rfp_ptr->addr
Rogue AP Detection Module LOG_INFO Number of known APs: %u count
Statistics Module LOG_INFO Resetting
VLAN Module LOG_INFO Mapped port [Number] to subnet [Number]
VLAN Module LOG_INFO Mapped wlan [Number] to subnet [Number]
VLAN Module LOG_INFO Port [Number] has no subnet mapping port_idx
VLAN Module LOG_INFO Subnet [Number] disabled subnet_idx
VLAN Module LOG_INFO Subnet [Number] enabled subnet_idx
VLAN Module LOG_INFO Wlan [Number] has no subnet mapping wlan_idx
SIP Module LOG_INFO SIP:Max number of SIP sessions reached on portal [address]
SIP Module LOG_INFO “SIP:Create a new SIP session for call id [identifier], set state to initiated”
SIP Module LOG_INFO SIP:Decrementing the number of Active SIP sessions of portal [address] to
[number]
SIP Module LOG_INFO SIP:Incrementing the number of Active SIP sessions of portal [address] to
[number]
WIPS module LOG_INFO WIPS is disabled
WIPS module LOG_INFO WIPS: Detection in progress
WIPS module LOG_INFO Could not send configuration to [MAC] Sensor was not found
WIPS module LOG_INFO WIPS: Max number of sensors detected. Not adding any more
WIPS module LOG_INFO AP [MAC] is converted to sensor
WIPS module LOG_INFO Sensor [MAC] is successfully reverted
System Component Debug Level Log Message