Specifications

Switch Administration 7-59
4. Check the Enable logging to CF check box to enable logging of events to a CF card on the switch. This
is useful when the connection to the Syslog server is lost due to network disturbances or any other cause.
When enabled, the event log is written to the CF card when the Syslog server is not available for any
reason. When the Syslog server comes back on line, the logging is automatically done to the server.
5. Select Apply to save the changes.
6. Select Network Configuration --> Subnet Access. Work through all the combinations of subnet-to-
WAN accesses to ensure that DNS communications are allowed. (UDP must be enabled to save the log
entries.)
7.14 Commands to unmount a CF card
To unmount a CF card used to load firmware use these commands from the console.
admin> system
admin(system)> exec cfumount
To see the contents of the CF card use these commands from the console.
admin> system
admin(system)> cf
admin(system.cf)> ls
.
..
mf12.bin
mf_02020200003R.bin
admin(system.cf)>
You can also use these commands to view the contents of the CF card.
admin(system)> exec df –h /mnt/cf