Specifications

Switch Administration 7-53
1. To set the SNMP traps, select System Configuration --> SNMP Access --> SNMP Traps from the
left menu.
2. Check the type of traps to enable the generation of notification events.
Trap
Category
Trap Name Generates a Trap whenever…
System
Traps
System Cold Start The switch’s router reinitializes while transmitting, possibly altering the
agent’s configuration or protocol entity implementation.
Configuration
Changes
SNMP access or management functions are reconfigured.
User Login Failure A user fails to successfully login from the CLI or Applet.
Admin Password
Change
A change is made to the Admin user password.
Low Compact Flash
Memory
The memory in the Compact Flash card in the system falls below the
amount specified.
Network
Traps
Physical port status
change
The status changes for one of the ports on the front of the WS2000, such
as if a device is plugged into or unplugged from the switch, or if the link is
lost between the switch and the connected device.
Interface Status
Change
An interface on the switches status changes from its configured state.
DynDNS Update If Dynamic DNS services are configured on the WAN a new trap is set
when there is a Dynamic DNS update.
Denial of service
(DOS) attempts
A Denial of Service attack is detected by the switch’s firewall. A new trap
will be sent at the interval specified until the attack has stopped.