Wireless Ethernet Bridge User Guide

Section 2
Installation
2-6 WE800G
2 Click the Print icon or choose Print from the File menu to display
the Print dialog box. (A sample print dialog appears below.)
In both the Pages from and to fields, enter the page number on
which the Wall Mounting Template appears.
Be sure you print the template at 100% scale and that Fit to page
is not
checked in the Print dialog box.
3 Click OK to print the template.
4 Measure the printed template with a ruler to ensure that it is the
correct size.
5 Use a center punch to mark the center of the holes on the wall.
6 On the wall, locate the marks for the mounting holes you just
made.
WARNING!
Before drilling holes, check the structure for potential
damage to water, gas, or electric lines.
7 Drill the holes to a depth of at least 3.8 cm (1½ inches).
8 If necessary, seat an anchor in each hole. Use M5 x 38 mm
(#10-16 x 1½ inch) screws with a flat underside and maximum
screw head diameter of 10.5 mm to mount the WE800G.