User manual

AP User Manual January 2004
Software Release 4.1
Site Location
The operator enters information about the physical location of the module. This parameter is written
into the sysLocation SNMP MIB-II object and can be polled by an SNMP management server. The
buffer size for this field is 128 characters.
8.3.2 Configuration Buttons
The Configuration page provides the following buttons:
Save Changes
When the operator clicks this button, any changes that have been made on the Configuration page
are recorded in flash memory. However, these changes do not apply until the next reboot of the
module.
Undo Saved Changes
When the operator clicks this button, any changes that have been made but were not committed by
a reboot of the module are undone.
Set to Factory Defaults
When the operator clicks this button, all configurable parameters are reset to the factory settings.
Reboot
When the operator clicks this button, the module reboots. When the operator has changed
parameters in the Configuration page, the system highlights Reboot button as a reminder that a
reboot (in addition to a save) is required to implement the changes.
8.4 IP CONFIGURATION PAGE
An example of the IP Configuration screen is displayed in Figure 30.
Figure 30: IP Configuration screen
Issue 5 Page 86 of 102