User manual

AP User Manual January 2004
Software Release 4.1
Where the high-priority channel is desired, all high-priority parameters must be set. If all
are not set, then the high-priority channel is not active.
Total NumUAckSlots
The operator specifies how many slots are used to acknowledge data that an SM receives. The
default value of this parameter is 3. This value should be kept, except when the operator
anticipates a high amount of traffic. If the value of 3 is entered for the following (Uacks Reserved
High) parameter, then this parameter should be set to 6. The allowed range for this parameter is
1 to 7.
If the AP is in cluster, then this parameter must be set exactly the same on all other
modules in the cluster.
Uacks Reserv
Dacks Reserv
ed High
The operator specifies how many slots are used to acknowledge high-priority data that an SM
receives. This parameter should be set only when the high-priority channel is used. In this case,
the recommended value of this parameter is 3.
NumDAckSlots
The operator specifies how many slots are used to acknowledge data that the AP receives. The
default value of this parameter is 3. This value should be kept, except when the operator
anticipates a high amount of traffic. If the value of 3 is entered for the following (Dacks Reserved
High) parameter, then this parameter should be set to 6. The allowed range for this parameter is
1 to 7.
If the AP is in cluster, then this parameter must be set exactly the same on all other
modules in the cluster.
ed High
The operator specifies how many slots are used to acknowledge high-priority data that the AP
receives. This parameter should be set only when the high-priority channel is used. Inthis case,
the recommended value of this parameter is 3.
NumCtlSlots
The operator specifies how many slots are used to send control messages to an AP. The default
value of this parameter is 3. This value should be kept, except when the operator anticipates a high
amount of traffic. If the value of 3 is entered for the following (NumCtlSlots Reserved High)
parameter, then this parameter should be set to 6. The allowed range for this parameter is 1 to 16.
If the AP is in cluster, then this parameter must be set exactly the same on all other
modules in the cluster.
NumCtlSlots Reserved High
The operator specifies how many slots are used to send control messages to an AP. This
parameter should be set only when the high-priority channel is used. In this case,
the recommended value of this parameter is 3.
Issue 5 Page 80 of 102