User manual

AP User Manual January 2004
Software Release 4.1
Uptime
This field indicates how long the module has operated since power was applied.
System Time
This field provides the current time. If the AP is connected to a CMM, then this field provides GMT
(Greenwich Mean Time). Any SM that registers to the AP inherits the system time.
Ethernet Interface
This field indicates the configuration of the Ethernet interface on the module.
Registered SM Count
This field indicates how many SMs are registered to the AP.
GPS Sync Pulse Status
This field indicates the status of synchronization that the AP is receiving as follows:
• Generating sync indicates that the module is set to generate the sync pulse.
• Receiving Sync indicates that the module is set to receive a sync pulse from an
outside source and is receiving the pulse.
• ERROR: No Sync Pulse indicates that the module is set to receive a sync pulse from
an outside source and is not receiving the pulse.
NOTE: When this message is displayed, the AP transmitter is turned off to avoid
self-interference within the Canopy system.
Site Name
This field indicates the name of the physical module. The operator can assign or change this name
on the Configuration web page. This information is also set into the sysName SNMP MIB-II object
and can be polled by an SNMP management server.
Site Contact
This field indicates contact information for the physical module. The operator can provide or
change this information on the Configuration web page. This information is also set into the
sysName SNMP MIB-II object and can be polled by an SNMP management server.
Issue 5 Page 77 of 102