User manual

AP User Manual January 2004
Software Release 4.1
8.1.1 Quick Start Available Pages
Buttons on the left-hand side of the Quick Start page provide access to the following other pages:
Quick Start
Status
Configuration
IP Configuration
Event Log
LUID Select
Link Test
Time & Date
Sessions
GPS Status
Ethernet Stats
Expanded Stats
8.1.2 Quick Start Operator Options
Quick Start is a wizard that helps the operator to perform a basic configuration that places an AP
into service. Only the following parameters must be configured:
• RF Carrier Frequency
• Synchronization
• Network IP Address
In each page under Quick Start, the operator can
• specify the settings that best address the requirements of the network.
• review the configuration selected.
• save the configuration to non-volatile memory.
Experimentation with the interface is encouraged. Unless the confiugration is saved, none of the
changes affect the system.
Issue 5 Page 75 of 102