User manual

AP User Manual January 2004
Software Release 4.1
7 AP MODULE INSTALLATION
The following steps are required to install a Canopy AP:
1. Unpacking the Canopy Products. See Page 61.
2. Cabling the AP. See Page 62.
3. Configuring the AP. See Page 67.
4. Installing the AP and, optionally, the CMM and GPS (Global Positioning System) antenna.
See Installing the AP on Page 70.
5. Verifying System Performance See Page 72.
7.1 UNPACKING THE CANOPY PRODUCTS
Upon receipt, carefully inspect all shipping boxes for signs of damage. If you find damage,
immediately notify the transporatation company.
Unpack the equipment, making sure that all of the components ordered have arrived. Saving all the
packing materials is recommended. These can be used to either return products or transport the
equipment to and from installation sites.
7.1.1 Component Layout
The simple design of the Canopy AP allows for easy deployment. As shown Figure 24, the base
cover of the module snaps off when a lever on the back of the base cover is depressed. This
exposes the Ethernet and GPS sync connectors and diagnostic LEDs.
Ethernet
Cable
Canopy AP
RJ45
Connector
Connection
LEDs
Base Cover
RJ11
Connector
Ethernet
Cable
Base Cover
Release
Lever
Base Cover
Figure 24: Canopy AP base cover, attached and detached
Issue 5 Page 61 of 102