User manual

AP User Manual January 2004
Software Release 4.1
Where spectrum analysis identifies risk of interference for any of these channels, the planner can
compromise this recommendation as follows:
• Select 2.4375 GHz for the middle channel
• Select 2.455 GHz for the top channel
• Select 2.4175 GHz for the bottom channel
In any case, the plan should allow at least 20 MHz of separation between channels. See Spectrum
Analysis on Page 50.
5.5.5 5.2-GHz AP Channels
Channel selections for the AP in the 5.2-GHz band depend on whether the AP is deployed in
cluster.
5.2-GHz Single AP Available Channels
A single 5.2-GHz AP can operate in the following channels, which are separated by 5-MHz
increments as advised in the caution above.
(All Frequencies in GHz)
5.275 5.290 5.305 5.320
5.280 5.295 5.310 5.325
5.285 5.300 5.315
The channels of adjacent APs should be separated by at least 20 MHz. However, 25 MHz of
separation is advised.
5.2-GHz AP Cluster Recommended Channels
Three non-overlapping channels are recommended for use in a 5.2-GHz AP cluster:
(All Frequencies in GHz)
5.275 5.300 5.325
Issue 5 Page 53 of 102