Specifications

13 - 12 WiNG 5.2.6 Wireless Controller CLI Reference Guide
13.1.3.2 dhcp-pool-mode
 dhcp-pool
Configures the DHCP pool commands
Table 13.5 summarizes DHCP pool commands
Table 13.5 dhcp-pool mode commands
Command Description Reference
address Specifies a range of addresses for a DHCP pool page 13-13
bootfile Assigns a bootfile name. The bootfile name can contain letters, numbers, dots
and hyphens (consecutive dots and hyphens are not permitted)
page 13-14
ddns Configures dynamic DNS parameters page 13-15
default-router Configures a default-router or gateway IP address for the network pool page 13-16
dns-server Sets the DNS server’s IP address available to all DHCP clients connected to the
DHCP pool
page 13-17
domain-name Sets the domain name for the network pool page 13-18
excluded-address Prevents a DHCP server from assigning certain addresses to the DHCP pool page 13-19
lease Sets a valid lease for the IP address used by DHCP clients in the DHCP pool page 13-20
netbios-name-
server
Configures NetBIOS (WINS) name server IP address page 13-21
netbios-node-type Defines the NetBIOS node type page 13-22
next-server Configures the next server in the boot process page 13-23
no Negates a command or sets its default page 13-24
option Configures RAW DHCP options page 13-28
respond-via-
unicast
Sends a DHCP offer and a DHCP Ack as unicast messages page 13-29
update Controls the usage of DDNS service page 13-49
static-binding Configures static address bindings for a DHCP pool page 13-30
static-route Configures a static route for a DHCP pool page 13-48