Specifications

2 - 34 WiNG 5.2.6 Wireless Controller CLI Reference Guide

2.1.15 no



user exec mode commands

Use the no command to revert a command or to set parameters to their default. This command is useful to turn off an

enabled feature or set default values for a parameter.

Supported in the following platforms:

• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX

• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500

Syntax

no adoption {on <DEVICE-OR-DOMAIN-NAME>}

no captive-portal client [captive-portal <CAPTIVE-PORTAL-NAME>|<MAC>]

{on <DEVICE-OR-DOMAIN-NAME>}

no crypto pki [server|trustpoint]

no crypto pki [server|trustpoint] <TRUSTPOINT-NAME> {del-key {on <DEVICE-NAME>}|

on <DEVICE-NAME>}

no logging monitor

no page

no service [ap300|cli-tables-expand|locator]

no service ap300 locator <MAC>

no service [cli-tables-expand <LINE>|locator {on <DEVICE-NAME>}]

no terminal [length|width]

no wireless client [all {filter|on}|<MAC>]

no wireless client all {filter [wlan <WLAN-NAME>]}

no wireless client all {on <DEVICE-OR-DOMAIN-NAME>} {filter [wlan <WLAN-NAME>]}

no wireless client <MAC> {on <DEVICE-OR-DOMAIN-NAME>}

Parameters

• no adoption {on <DEVICE-OR-DOMAIN-NAME>}

• no captive-portal client [captive-portal <CAPTIVE-PORTAL-NAME>|<MAC>]

{on <DEVICE-OR-DOMAIN-NAME>}

NOTE: The commands have their own set of parameters that can be reset.

no adoption

{on <DEVICE-OR-DOMAIN-

NAME>}

Resets the adoption status of a specified device or all devices adopted by a device

• <DEVICE-OR-DOMAIN-NAME> – Optional. Specify the name of the AP, wireless

controller, or RF Domain.

no captive-portal client Disconnects captive portal clients from the network

captive-portal

<CAPTIVE-PORTAL-NAME>

Disconnects captive portal clients

• <CAPTIVE-PORTAL-NAME> – Specify the captive portal name.

<MAC> Disconnects a specified client

• <MAC> – Specify the MAC address of the client.